Dead-Time Effect Compensation Based on Additional Phase Current Measurements PROJECT TITLE :Dead-Time Effect Compensation Based on Additional Phase Current MeasurementsABSTRACT:This paper proposes a new methodology of dead-time effect compensation. The proposed resolution is predicated on additional phase current measurements realized by analog-to-digital converters. These measurements are distributed at the time instants specified by a pulsewidth-modulation (PWM) strategy. This makes it attainable to estimate inverter currents at the commutation instants and, finally, to estimate the voltage error caused by dead time. This voltage error is compensated during the subsequent switching amount by modification of a reference voltage. The proposed solution can be used to compensate the voltage error in multilevel multiphase voltage supply inverters. The experimental analysis studies were allotted on three-section 2-level and three-level neutral-purpose-clamped inverters supplying fifty five- and a hundred and sixty-kW motors, respectively. The results of the experimental investigations are presented in this paper. Did you like this research project? To get this research project Guidelines, Training and Code... Click Here facebook twitter google+ linkedin stumble pinterest New Control of PV Solar Farm as STATCOM (PV-STATCOM) for Increasing Grid Power Transmission Limits During Night and Day Adapting Team-Based Learning for Application in the Basic Electric Circuit Theory Sequence