ABSTRACT:

This paper deals with the design & development of a theft Control System for an automobile, which is being used to prevent/control the theft of a vehicle. The developed system makes use of an embedded system based on GSM technology. The designed & developed system is installed in the vehicle. An interfacing mobile is also connected to the microcontroller, which is in turn, connected to the engine. Once, the vehicle is being stolen, the information is being used by the vehicle owner for further processing. The information is passed onto the central processing insurance system, where by sitting at a remote place, a particular number is dialed by them to the interfacing mobile that is with the hardware kit which is installed in the vehicle. By reading the signals received by the mobile, one can control the ignition of the engine; say to lock it or to stop the engine immediately. Again it will come to the normal condition only after entering a secured password. The owner of the vehicle & the central processing system will know this secured password. The main concept in this design is introducing the mobile Communications into the embedded system. The designed unit is very simple & low cost. The entire designed unit is on a single chip. When the vehicle is stolen, owner of vehicle may inform to the central processing system, then they will stop the vehicle by just giving a ring to that secret number and with the help of SIM tracking knows the location of vehicle and informs to the local police or stops it from further movement.


Did you like this research project?

To get this research project Guidelines, Training and Code... Click Here


PROJECT TITLE : Compromised Controller Design for Current Sharing and Voltage Regulation in DC Microgrid ABSTRACT: It is easy to see how voltage controller tuning provides a clear and intuitive tradeoff between the opposing
PROJECT TITLE : Design of Power Decoupling Strategy for Single-Phase Grid-Connected Inverter Under Non-Ideal Power Grid ABSTRACT: Single-phase inverters require large electrolytic capacitors to decouple the dc bus from the
PROJECT TITLE : Design and Implementation of a Variable Synthetic Inertia Controller for Wind Turbine Generators ABSTRACT: The rising use of Renewable Energy Sources (RES) and converter-connected power generation is reducing
PROJECT TITLE : Design and Development of MATLAB Based Three Phase Converter for Unbalanced AC Source ABSTRACT: The primary goal of this project is to build a control circuit with components in the zero sequence, although
PROJECT TITLE : Design of a Sliding-Mode-Controlled SEPIC ABSTRACT: This paper describes how to create a sliding-mode controller for photovoltaic (PV) systems that tracks the maximum power point. However, it is applicable

Ready to Complete Your Academic MTech Project Work In Affordable Price ?

Project Enquiry