Residual stress modeling of density modulated silicon thin films using finite element analysis PROJECT TITLE :Residual stress modeling of density modulated silicon thin films using finite element analysisABSTRACT:Density modulated thin films offer a compliant property that can reduce residual stress, which typically originate during the growth of thin films. Lower residual stress improves adhesion properties of the film with reduced buckling or delamination, and therefore leads to more durable coatings. In this study, finite element analysis (FEA) was employed to simulate the residual stresses developed in density modulated silicon (Si) thin films, which incorporate alternating low and high density layers. The main focus of this investigation is not developing new FEA algorithms but to verify the impact of density modulated layers quantitatively using computational methods. Hence, verification of a predicted stress reduction enhances the current understanding of the mechanics of density modulated layered thin films. FEA simulation results reveal that low density layers act compliant and result in significant reduction in film stress especially at the interface with the substrate. For example, maximum stress at the film/substrate interface, which is in the substrate, was reduced from 2897 MPa down to 2432 MPa by simply adding a 100 nm thick density-modulated low-density Si layer in between a 300 μm thick Si wafer substrate and 1 μm thick conventional high density Si film, which makes the reduction percentage of the maximum stress about 16%. Did you like this research project? To get this research project Guidelines, Training and Code... Click Here facebook twitter google+ linkedin stumble pinterest Comparison of defects in crystalline oxide semiconductor materials by electron spin resonance Study on contact distortion during high aspect ratio contact SiO2 etching
