Rate-state friction in microelectromechanical systems interfaces: Experiment and theory PROJECT TITLE :Rate-state friction in microelectromechanical systems interfaces: Experiment and theoryABSTRACT:A microscale, multi-asperity frictional test platform has been designed that allows for wide variation of normal load, spring constant, and puller step frequency. Two different monolayer coatings have been applied to the surfaces—tridecafluorotris(dimethylamino)silane (FOTAS, CF3(CF2)5(CH2)2 Si(N(CH3)2)3) and octadecyltrichlorosilane (OTS, CH3(CH2)17SiCl3). Static friction aging was observed for both coatings. Simulating the platform using a modified rate-state model with discrete actuator steps results in good agreement with experiments over a wide control parameter subspace using system parameters extracted from experiments. Experimental and modeling results indicate that (1) contacts strengthen with rest time, exponentially approaching a maximum value and rejuvenating after inertial events, and (2) velocity strengthening is needed to explain the shorter than expected length of slips after the friction block transitions from a stick state. We suggest that aging occurs because tail groups in the monolayer coatings reconfigure readily upon initial contact with an opposing countersurface. The reconfiguration is limited by the constraint that head groups are covalently bound to the substrate. Did you like this research project? To get this research project Guidelines, Training and Code... Click Here facebook twitter google+ linkedin stumble pinterest Microstructure from joint analysis of experimental data and ab initio interactions: Hydrogenated amorphous silicon Study of stacked-emitter layer for high efficiency amorphous/crystalline silicon heterojunction solar cells