Diagnosis and Prognosis for Complicated Industrial Systems—Part II


This special section on "Diagnosis and Prognosis for complicated Industrial Systems???Part II??? is that the continuation of its previous half I (IEEE Transactions on Industrial Electronics, Vol. sixty three, Issue 4, 2016). The diagnosis and prognosis approaches will be roughly classified into 2 categories: one) model-based mostly and 2) knowledge-driven approaches. The model-based approaches perform the diagnosis and prognosis relying on the physical models from 1st principles, whereas the info-driven approaches create full use of the method knowledge to observe the systems beneath thought. Because of the increasing complexity of the commercial system, new challenges are encountered in diagnosis and prognosis of such complicated systems, and more efficient method monitoring approaches are required. From this point of read, the papers included during this section are centered on the recent developments of diagnosis and prognosis for classy industrial systems, providing novel ideas and referential directions for each the educational and industrial communities.

Did you like this research project?

To get this research project Guidelines, Training and Code... Click Here

PROJECT TITLE :Conditional (t,k) -Diagnosis in Regular and Irregular Graphs Under the Comparison Diagnosis Model - 2018ABSTRACT:Assume that there are at most t faulty vertices. A system is conditionally (t, k)-diagnosable if
PROJECT TITLE :Current Sensor Fault Diagnosis and Tolerant Control for VSI-Based Induction Motor Drives - 2017ABSTRACT:Fault-tolerant control is attracting a lot of interests because of its capability of increasing the reliability
PROJECT TITLE : A Test Selection Procedure for Improving the Accuracy of Defect Diagnosis - 2016 ABSTRACT: Procedures that were described earlier increase the accuracy of defect diagnosis by ignoring little subsets of tests
PROJECT TITLE: Scan Chain Masking for Diagnosis of Multiple Chain Failures in a Space Compaction Environment - 2015 ABSTRACT: Diagnosis is extremely vital to ramp up the yield during the integrated circuit manufacturing method.
PROJECT TITLE : Diagnosis of single-phase open-line fault inthree-phase PWM rectifier with LCL filter - 2016 ABSTRACT: In this study, the transient process when the one-part open-line fault (SPOLF) occurs within the three-phase

Ready to Complete Your Academic MTech Project Work In Affordable Price ?

Project Enquiry