AlN film SAW resonator integrated with metal structure


A novel surface acoustic wave (SAW) resonator integrated on a metal substrate is presented. The devices were fabricated on the aluminium nitride (AlN) thin films deposited by mid-frequency magnetron sputtering on polished TC4 titanium alloy substrates. Using a two-step growth method, AlN film with a full-width at half-maximum of 4.1° had been prepared. The AlN film SAW resonator shows a resonance frequency of 129 MHz and an electromechanical coupling coefficient of 0.28%. The measurement results agree well with the simulation results. This integrated SAW resonator can be used as a good strain sensor in metal structure health monitoring.

Did you like this research project?

To get this research project Guidelines, Training and Code... Click Here

PROJECT TITLE :AlN Barriers for Capacitance Reduction in Phase-Change RF SwitchesABSTRACT:We demonstrate four-terminal GeTe-based RF switches with independent thermal actuation (switching). These devices incorporate an AlN-based
PROJECT TITLE :Surface discharges in silicone gel on AlN substrateABSTRACT:AlN substrate is widely used together with silicone gel to encapsulate power electronic circuits. It is known that the weakness of the insulation system
PROJECT TITLE :Impact of AlN Interfacial Dipole on Effective Work Function of Ni and Band Alignment of Ni/HfO2/In0.53Ga0.47As Gate-StackABSTRACT:AlN has successfully been applied to passivate the oxide/III–V interface; but,
PROJECT TITLE :Quality Factor Dependence on the Inactive Regions in AlN Contour-Mode ResonatorsABSTRACT:This paper investigates the dependence of the standard issue (Q) of AlN contour mode resonators (CMRs) on the characteristics
PROJECT TITLE :Effect of Film Thickness on the Electrical Properties of AlN Films Prepared by Plasma-Enhanced Atomic Layer DepositionABSTRACT:During this paper, AlN thin films with two different thicknesses, i.e., 7 and 47 nm,

Ready to Complete Your Academic MTech Project Work In Affordable Price ?

Project Enquiry